GE Voluson P8 BT16 - 3-5-6 Connecting the Footswitch

GE DRAFT VOLUSON™ P8 / VOLUSON™ P6
DIRECTION 5723243, R
EVISION 6 DRAFT (MAY 23, 2018) BASIC SERVICE MANUAL
Chapter 3 - Setup Instructions 3-21
3-5-6 Connecting the Footswitch
The footswitch should be directly connected to any accessible USB-port on the Voluson™ P8 /
Voluson™ P6 (e.g., on rear of the system).
NOTE: Connection of the Footswitch is always the same.
After physical connection, adjust the Footswitch (Left/Right) as described in Section 3-9-1-7 "How to
adjust function of the Footswitch (Left/Middle/Right)" on page 3-67.
Figure 3-10 Footswitch connection scheme