GE Voluson P8 BT16 - Section 8-15 Replacement of ENCODER set

GE DRAFT VOLUSON™ P8 / VOLUSON™ P6
DIRECTION 5723243, R
EVISION 6 DRAFT (MAY 23, 2018) BASIC SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-35
Section 8-15
Replacement of ENCODER set
8-15-1 Manpower
One person, 40 minutes
8-15-2 Tools
Philips screw driver, spanner
8-15-3 Removal procedure
1.) Unscrew 9 screws at the bottom of the keyboard body. Refer to the figures below.
2.) Remove 5 probe holders. Refer to the figure below.
Figure 8-37 Unscrewing 9 screws
Figure 8-38 Removing 5 probe holders