GE RAFT VOLUSON™ P8 / VOLUSON™ P6
DIRECTION 5723243, R
EVISION 6 DRAFT (MAY 23, 2018) BASIC SERVICE MANUAL
3-20 Section 3-5 - Connection of Auxiliary Devices
3-5-5 Connecting the Wireless Network Adapter
The Wireless Network Adapter can be connected to any accessible USB port of the Voluson™ P8 /
Voluson™ P6.
NOTE: Connection of the WLAN Adapter is always the same.
1.) Turn ON the power of the system and wait till the system has booted.
2.) Plug the Wireless Network adapter into an accessible USB port of the Voluson™ P8 / Voluson™
P6.
All software drivers are pre-installed for the designated Wireless Network adapter only.
NOTE: After physical connection of the WLAN adapter to the Voluson™ P8 / Voluson™ P6 system, follow the
procedure described in Section 3-13-2 "Wireless Network Configuration" on page 3-76.
Figure 3-9 Connection Scheme - Wireless (USB) Network Adapter
To Next Page
Loading...
