80209C_MHW_850-1650-1850_01-2020_ENG_pag. 249
• Programmer Status (Run,Ready,End,Hbb)
• Programmer actual program (Number of the program currently
running)
• Programmer actual step (Number of the step currently running)
• Programmer actual segment (Ramp, Hold, end)
• Programmer actual time (time of the ramp/step currently
running)
• Programmer actual set point (setpoint of the step currently
running)
Click on the Maintenance link to go to the page
The page includes:
1. Counter switch (1,2,3,4) , thousands of switches
2. Total energy 1,2 used by pid 1,2
Go to the Info page to view the information listed below
There are two paragraphs on this page:
• MODELINFO WITH:
- SW version
- Serial code
- Input error1 and 2
- Sap code
- Serial Number
- Opt Hw and SW
• DIAGNOSTICS with:
- Working days ; total days of oforation
- Internal temp , internal temforature
- Min temp, minimum internal temforature
- Max temp, maximum internal temforature
Go to the WIZARD page and click on the link to access the
corresponding page
The information appearing on the page is as follows:
• OFF/ON instrument power down command
• P.MAN1,2 Power 1,2 delivered manually by the correspon-
ding PID
• MAN/AUTO 1 and 2, manual/automatic PID command
• REM/LOC 1 and 2, remote/local PID command
• The page is refreshed every 2.5 seconds. Proceed as
follows to set the parameters:
1. Click on Stop Refresh
2. Set the desired values
3. Select Submit
• The WIZARD page then starts refreshing again
To Next Page
Loading...
Need help?
General
