- 9 -
Maintenance Rules
Metric tools are preferable for the maintenance of this motorcycle. Improper tools may cause damage.
Clean up the surface of parts or assembly parts before removing or opening the shield for maintenance, which can
prevent dirt from falling into the engine, chassis or braking system.
Wash parts and dry with compressed air machine after
disassembly and before measurement of attrition value.
Solvent or oil can easily damage aging rubber articles. Check
rubber before reassembly and replace rubber if necessary.
When releasing assembly parts, please start from outside to inside.
Small assembly parts shall be loosened first.
Complex assembly parts, such as gear box, shall be stored in
proper order for facilitating installation in the future.
Please specially note the important connections before
disassembly. Replace parts which will not be in use before
disassembly.
Sheath
To Next Page
Loading...
Need help?
General
