25
3rd Wave User Manual
Oscillators
Tab 3 - Misc
Oscillator 2
Part 1
tuning reverse pitch on/o next osc
LIN FM AMT
FROM OSC 3
0
OSC SYNC
o
KEY TO WAVES
0
OSC LEVEL
100
B1-P040 Lush Layers OS v1.0
Osc Pitch: ONReverse: OFF
OSC LEVEL: (0-100) Sets the output level of the oscillator.
KEY TO WAVES: (0-127) Controls the Wave Offset using Note Number.
In other words, as you play up or down the keyboard, the wave offset
will change according to the key that you play. Higher values create a
broader range of timbral change across the keyboard. Setting
reverse
to on (by pressing soft button 2) changes the order that the wavetable is
spread across the keyboard so that the highest offset is at the bottom of
the keyboard and that offset 0 is at the top. This is the order that the PPG
used.
OSC SYNC: (On. Off) Turns on oscillator hard sync. Sync forces an Oscilla-
tor to restart its cycle every time the oscillator that is synced restarts its
cycle. For example, turning on Sync for Oscillator 1, syncs it to Oscil-
lator 2. Similarly, turning on Sync for Oscillator 2, syncs it to Oscillator
3. Turning on Sync for Oscillator 3, syncs it to Oscillator 1. This creates
harmonically complex waveforms, especially when the frequency of
Oscillator 1 is set to a higher or lower interval (pitch) than Oscillator 2.
For dramatic effects, modulate the pitch of the synced oscillator using the
Envelope 3 or 4.
Oscillator Sync is not currently available on User wavetables (“U” waves).
To Next Page
Loading...