GW Instek PEL-3000 Series - Page 131

FUNCTION MENU
129
Value
The current, voltage, power or
resistance setting for the
selected operating mode.
Time
0.05ms - 999h:59m
Sets the step time for the
selected step.
Load
ON, OFF
Turns the load on or off for the
selected step.
RAMP
ON, OFF
When turned on the current
transition is evenly ramped
from the start of the step to the
end of the step. When turned
off the current transition is
stepped.
Time
amplitude
Step time
Ramp = On
Time
amplitude
Step time
Ramp = Off
TRIG OUT
ON, OFF
When TRIG OUT is set to ON, a
trigger signal is output from the
TRIG OUT BNC terminal at the
start of the step. See page 185
for details.