GW Instek PEL-3000 Series - Page 133

FUNCTION MENU
131
Start:
S01 - S10
3. Select a Seq. No. and select which sequence to
edit.
Seq. No.:
S01 - S10
4. Set the following parameters for the currently
selected sequence. See page 126 for details on
each parameter.
 Memo
 Mode
 Range
 Loop
 Last Load
 Last
 Chain
5. Press Save[F3] to save the timing settings for the
currently selected sequence.
Sequence Timing configuration is complete.
 Go to Data Edit to edit the steps used in the
Normal Sequences. See page 132.
 Go to Running a Normal Sequence to run the
normal sequence. See page 133.