Figure 5-36 System Alert Setting by Web
No writable disk: There is no disk or the disk status is not available, such as read-only
disk.
Hard disk error: The connection between the disk and the device is error, such as the
data lines are broken.
Disk No Space: Alarm when the remaining space of the hard disk reaches the set value.
Network Disconnection: Alarm when the network cable is disconnected.
IP Conflict: Alarm when the IP address is the same as the others.
S.M.A.R.T: This exception is about HDD health detection. It will be triggered when the
HDD of device have some problems and not work under good condition. It supports these
methods to remind the user about the exception: Show Message and Buzzer.
5.6.7.2 Alarm
You can set up alarm port and linkage operations.
5.6.7.2.1 Alarm In
Click the Set ->Event ->Alarm ->Alarm In. As show in figure 5-37.
To Next Page
