Chapter 3 Getting Start
3.1 Start Up and Shut Down
Proper startup and shutdown procedures are crucial to expanding the life of the NVR. Please
check that the voltage of the power supply is the same with the NVR’s requirements, and the
ground connection is working properly.
Starting up the NVR
Plug-in the power supply and turn on the power switch (if there is one). The power supply
blinking indicator indicates the video recorder booting up. After the startup you will hear a beep.
The default setting of video output is multiple-window output mode. If the startup time is within
the recording schedule time, the video recording function will start up automatically. Then the
recording indicator of corresponding channel will start blinking confirming NVR is working
normally.
First start up
For security reason, the NVR requires you activate the admin’s password before login. It will show
you a change password dialog when the device is powered on for the first time.
Note:
The password can be set as numbers(0~9), English characters(a~z, A~Z), and other
symbols
The password must include at least 2 categories of character. The length support 6~64.
The password can be restored to empty by clicking “Maintain
Config
restore default”
Shutting down the NVR
Right-click the mouse on the live view interface and choose “Main Menu >Shutdown”, then click
the OK button, as shown in figure 3-1.
To Next Page
Loading...
