Figure 5-45 Fast Moving Setting
Fast Moving function detects people, vehicle, and some other objects that move with forbidden
speed; certain actions can be taken when the alarm is triggered.
Plot area: Set the detect areas.
Sensitivity: Change the sensitivity of the Area Intrusion. The higher the sensitivity the
easier it is to trigger alarm.
Channel: Can be set for each channel.
Enable: Area Intrusion enabled switch.
Arming Schedule: Set the alarm time.
Action: Include alarm output, show message, buzzer, send Emails, alarm recording, PTZ
Act, and tour.
5.6.7.3.8 Loitering Detection
Click the Set ->Event -> Smart Event -> Loitering Detection. As show in figure 5-46.
Journey: When people walk into and wander in an area, once the length he has wandered over
half of the longest diagonal line of this area, it will trigger the alarm.
Weight: When people go back and forth at least 3 times, or go in a non-linear path within a pre-
defined virtual region; certain actions can be taken when the alarm is triggered.
Offsets: When people change his original direction and walk for over half of the area, then it will
trigger the alarm.
Plot area: Set the detect areas.
Channel: Can be set for each channel.
Switch Setting: Set warning surface, time threshold and sensitivity.
Enable: Area Intrusion enabled switch.
Arming Schedule: Set the alarm time.
Action: Include alarm output, show message, buzzer, send Emails, alarm recording, PTZ
Act, and tour.
To Next Page
