Hammer A2-26 - Thickness Planing Safety Warnings; Thickness Planing: Infeed Side Steps

65
A2-26
Use
Thickness planing step 1 - infeed side
1
3
4
2
Fig. 50: Thickness planing - infeed side
1 Kickback guards
2 Processing direction when thicknessing
3 Start the cutterblock and feed
4 Lock the clamping lever (thicknessing table adjustment)
Material:
● Super-Gleit
1.
Take note of general procedures for permitted working methods. link
target doesn't
exist but @y.link.required='true'
2.
Every time the machine is put into operation, test the kickback guards to
ensur
e that they are functioning properly.
3.
Switch on the machine, start the drive motor.
T
he feed gear runs automatically when the drive motor is switched on.
6.
Place the surface-planed side of the workpiece on the thicknesser table and
push int
o the machine until it is drawn in by the feed rollers.
7.
Processing several workpieces:
● Infeed roller standard:
with several workpieces being simultaneously processed:
Insert the two workpieces at each end of the transport roller.