Hammer A2-26 - Thickness Planing: Outfeed Side Steps

66
Use
Thickness planing step 2 - outfeed side
2
1
Fig. 51: Thickness planing - outfeed side
1 Processing direction when thicknessing
2 Support the workpiece
1.
The workpiece must be supported when it comes out of the rear of the
mac
hine to prevent it from tipping over.
2.
Remove the workpiece from the machine.
3.
Adjust the thicknessing height before planing again.
P
ay attention to maximum depth of cut.
4.
Push the workpiece back into the machine on the infeed side.