Harris Constellation - Receiver Assembly

Index I-5
Harris Corporation Constellation™
INDEX
hidden menu
Configuration submenu B-10
, B-12
Control submenu B-9
Performance submenu B-8
High Level Mux 1-4
, 1-13
configuring 7-1
front view 12-26
installing 12-27
LED indicators, location 12-26
locking traffic 12-27
removing 12-26
HLM-155
installing 12-29
locking traffic 12-28
, 12-30
HLM-155 electrical interface, loopback test
5-12
HLM-3xDS3
installing 12-30
hours, business
Technical Assistance Center 13-5
I
IF cable
receiver 12-7
IF filter
Receiver Assembly 12-19
IF filter, removing and installing, Receiver
Assembly 12-17
IF loopback test 5-2
impulse noise, source of 3-1
injury caused by improper practices 2-1
inspection, equipment 3-1
installation
waveguide 4-19
installation procedures 4-6
detailed 4-9
installing
Constellation radio rack 4-9
High Level Mux 12-27
HLM-155 12-29
HLM-3xDS3 12-30
M12 Unit 12-34
Modem 12-25
Power Supply 12-22
Receiver Assembly 12-20
Service Channel 12-32
SPU Controller 12-33
Standby M12 Unit 12-34
interconnection cables
connecting 4-6
interconnection cables for customers A-7
interconnection cabling 4-12
requirements 4-14
interference 2-4
Internet address
customer service F-5
Technical Assistance Center F-5
IP parameter changes 8-8
IP routing 8-3
table 8-3
IP ROUTING command, Configuration
submenu B-10
J
JP1 settings 12-16
K
Keypad 1-14, 1-15, 1-16, 4-7, A-6, B-1
adjusting the Tx frequency 4-24
, 4-26,
9-4
cable B-2
function B-1
layout B-3
main menu B-5
picture 12-6
pinouts A-10
, B-3
port A-9
port location 4-13
, A-8
procedure
adjusting the RF output power 4-30
,
9-8
removing 12-5
routine maintenance 9-1
screen format B-2
serial interface B-2
technical data B-3
Keypad menu
Alarm B-6
Configuration B-10
Control B-9
Performance B-8
Status B-7
Keypad port 10-3
L
label, transmit monitor port 4-28, 4-29,
9-6
, 9-7