Helmer iBX080 - Page 4

360179-A/B iii
8 i.C³
®
Control System .......................................................21
8.1 Home Screen and HaemoBank™ Screensaver ..............................................21
8.1.1 Home Screen Functions ..........................................................21
8.2 Alarm Reference ......................................................................21
8.3 Settings .............................................................................22
8.3.1 Temperature Settings ............................................................22
8.4 Sensor Calibration .....................................................................23
8.4.1 View Sensor Calibration Values ....................................................23
8.4.2 Change Sensor Calibration O󰀨set Values ............................................24
8.5 Factory Default Settings ................................................................24
8.6 Restore Factory Default Settings .........................................................25
8.7 View System Information ................................................................25
Section III: Maintenance & Service ...................................26
9.1 Alarm Tests ..........................................................................26
9.1.1 Automatic Chamber Temperature Alarm Test ..........................................26
9.1.2 Manual Chamber Alarm Test ......................................................27
9.1.3 Power Failure Alarm Test .........................................................28
9.1.4 Door Open Alarm Test ...........................................................28
9.2 Upgrade System Firmware ..............................................................28
9.3 Test and Replace Backup Batteries .......................................................28
9.3.1 Test the i.C
3
®
Monitoring System / Access Control Backup Battery .........................28
9.3.2 Replace the i.C
3
®
Monitoring System / Access Control Backup Battery ......................29
9.3.3 Check the Access Console Backup Battery ...........................................29
9.3.4 Replace the Access Console Backup Battery .........................................29
9.3.5 Check the Chart Recorder Backup Battery (If installed) ..................................30
9.3.6 Replace the Chart Recorder Backup Battery ..........................................31
9.4 Check Probe Bottle ....................................................................31
9.4.1 Check Probe Bottle Solution ......................................................31
9.4.2 Inspect and Replace Probe Bottle ..................................................31
9.5 Inspect and Secure Electrical Wiring and Terminals ...........................................32
9.6 Clean the Compartmental Access Refrigerator and Access Console ..............................33
9.6.1 Compartmental Access Refrigerator Condenser Grill ...................................33
9.6.2 Compartmental Access Refrigerator Exterior ..........................................33
9.6.3 Access Console and Consumable Cart Exterior .......................................33
9.6.4 Compartmental Access Refrigerator Interior ..........................................33
9.6.5 Door Gaskets ..................................................................34
9.6.6 Clean the Tray Assembly .........................................................34
9.6.7 Clean Probe Bottle and Rell Solution ...............................................34
9.6.8 i.C³
®
Touchscreen ...............................................................35
9.6.9 BloodTrack
®
Kiosk ..............................................................35
9.7 Bypass System Check and Reset .........................................................35
10 Service ..................................................................36
10.1 Refrigerant Charge ....................................................................36
10.2 Replace Chamber LED Lamp Strip ........................................................36
10.3 Maintaining Tray Assembly ..............................................................37
10.3.1 Remove and Install a Tray and Cover ...............................................37
10.3.2 Replace Tray Bumpers ...........................................................39