3.2.2.2 TOSS Locations for Different Transmissions ...................................................................................................... 24
3.2.3 Connect the Lever Sensor Connector, if applicable........................................................................................... 24
3.2.4 Connect to the Reproduced TOSS Signal ........................................................................................................... 25
3.2.5 Connect the Transfer Case Calculation Wire (4WD) ........................................................................................... 25
3.3 Install the Power & Engine Harness ...................................................................................... 25
3.3.1 Connect the Throttle Position Sensor................................................................................................................. 26
3.3.2 Connect the Power and Meter Leads .................................................................................................................. 26
3.3.3 Connect the Switch-Shift Harness ...................................................................................................................... 27
3.3.4 Connect the Overdrive Cancel Switch and Indicator ......................................................................................... 27
3.3.5 CAN Bus Connector .............................................................................................................................................. 27
3.4 Install or Connect a Throttle Position Sensor....................................................................... 27
3.4.1 Install the AccuLink TPS (Optional)..................................................................................................................... 27
3.4.1.1 Find the AccuLink TPS Parts................................................................................................................................ 28
3.4.1.2 Assemble the AccuLink TPS and Bracket............................................................................................................ 28
3.4.1.3 Assemble and Install the Ratio Arm .................................................................................................................... 29
3.4.1.4 Align the Ratio Arm .............................................................................................................................................. 29
3.4.1.5 Assemble the Adjustable Arm.............................................................................................................................. 30
3.4.1.6 Attach The Throttle Position Sensor................................................................................................................... 30
3.4.1.7 Set the Adjustable Arm Length............................................................................................................................ 31
3.4.1.8 Install the Adjustable Arm ................................................................................................................................... 31
3.4.1.9 Check the Adjustable Arm & TPS......................................................................................................................... 31
3.4.1.10 Check The Linkage ............................................................................................................................................... 32
3.4.1.11 Connect the AccuLink TPS to the Harness.......................................................................................................... 33
3.4.1.12 Secure the Wiring Harness to the AccuLink TPS................................................................................................. 34
3.4.2 Install the Cable-Operated TPS (Optional) ......................................................................................................... 34
3.4.2.1 Install the Cable TPS ............................................................................................................................................ 34
3.4.2.2 Mount the Cable Bracket ..................................................................................................................................... 35
3.4.2.3 Mount the Sensor Box.......................................................................................................................................... 35
3.4.3 Install the EFI TPS Adapter Harness (Optional).................................................................................................. 36
3.4.3.1 EFI with a General Motors throttle position sensor............................................................................................ 36
3.4.3.2 Other Systems ...................................................................................................................................................... 36
3.5 Install the Switch-Shift Wiring Harness (Optional)............................................................... 37
3.5.1 Connect the Three (3) Leads................................................................................................................................ 38
3.5.2 Connect to the Power & Engine Harness ............................................................................................................ 38
3.6 Install the A-B Mode Switch (Optional) ................................................................................. 39
To Next Page
Loading...
Need help?
General