Education Sharing System User Manual
64
The value of the RTSP port No. should be 554 or between 1024 and 65535, while the value of
the other ports should be between 1 and 65535 and the value must be different from each
other. If multiple devices are configured for the UPnP™ settings under the same router, the
value of the port No. for each device should be unique.
Click Apply button to save the settings.
Manual Mapping
Purpose:
If your router does not support the UPnP™ function, perform the following steps to map the port
manually in an easy way.
Before you start:
Make sure the router support the configuration of internal port and external port in the interface
of Forwarding.
Go to Configuration > System Settings > Network Settings> UPnP.
Uncheck Enable UPnP™.
Click on a value of External Port. And enter the external port No. for server port, http port,
RTSP port, and https port respectively.
The value of the RTSP port No. should be 554 or between 1024 and 65535, while the value of the
other ports should be between 1 and 65535 and the value must be different from each other. If
multiple devices are configured for the UPnP™ settings under the same router, the value of the
port No. for each device should be unique.
Click Save to save the settings.
Enter the virtual server setting page of router; fill in the blank of Internal Source Port with
the internal port value, the blank of External Source Port with the external port value, and
other required contents.
Each item should be corresponding with the device port, including server port, http port, RTSP port
and https port.
Setting Virtual Server Item
To Next Page
Loading...
