User Manual of Digital Video Recorder
132
Figure 8. 3 Set Arming Schedule of Motion Detection
5. Click Linkage Action tab to set alarm linkage actions of motion detection (please refer to Chapter 8.7).
Figure 8. 4 Set Alarm Linkage Actions of Motion Detection
Upload captured pictures to FTP is only supported by DVR series.
Click Apply to save the settings. Click OK to complete the motion detection settings of the channel.
6. If you want to set motion detection for another channel, repeat the above steps or just click Copy in the
Motion Detection interface to copy the above settings to it.
You are not allowed to copy the “Trigger Channel” action and motion detection settings to IP camera.
To Next Page
Loading...
Need help?
General