User Manual of Digital Video Recorder
192
6. Select the Group number for the current HDD.
The default group No. for each HDD is 1.
7. Click OK and confirm the pop-up message box to finish the settings.
11.4.2 Setting HDD Property
Purpose:
The HDD property can be set to redundancy, read-only or read/write (R/W). Before setting the HDD property,
please set the storage mode to Group (refer to step1-4 of Chapter 11.4.1 Setting HDD Groups).
A HDD can be set to read-only to prevent important recorded files from being overwritten when the HDD becomes
full in overwrite recording mode.
When the HDD property is set to redundancy, the video can be recorded both onto the redundancy HDD and the
R/W HDD simultaneously so as to ensure high security and reliability of video data.
Steps:
1. Enter the HDD Information interface.
Menu > HDD > General
2. Select a HDD from the list and click to enter the Local HDD Settings interface.
Figure 11. 12 Set HDD Property
3. Set the HDD property to R/W, Read-only or Redundancy.
4. Click OK to save the settings and exit the interface.
5. In the HDD Information menu, the HDD property will be displayed in the list.
At least 2 hard disks must be installed on your device when you want to set a HDD to Redundancy, and there is
one HDD with R/W property.
To Next Page
Loading...
Need help?
General