User Manual of Digital Video Recorder
45
3.2.2 Using the Mouse in Live View
Figure 3. 1 Right-click Menu
Table 3. 5 Mouse Operation in Live View
Enter the main menu of the system by right clicking the mouse.
Switch to the single full screen by choosing channel number from the drop-down list.
Adjust the screen layout by choosing from the drop-down list.
Switch to the previous screen.
Switch to the next screen.
Enable/disable the auto-switch of the screens.
Start all-day normal recording or motion detection recording for all channels.
Add IP camera to the device.
Play back the video of the selected channel.
Enter the PTZ control panel in live view mode.
Set the video output mode to Standard, Bright, Gentle or Vivid.
Switch to the auxiliary output mode.
The dwell time of the live view configuration must be set before using Start Auto-switch. Refer to Chapter
3.3 for dwell time settings.
If you enter Aux monitor mode and the Aux monitor is not connected, the mouse operation is disabled; you
need to switch back to the Main output with the MAIN/AUX button and Enter button on the front panel or
remote.
Add IP Camera is only available for the HDVR series.
To Next Page
Loading...
Need help?
General