User Manual of Digital Video Recorder
70
5.2 Configuring Record/Capture Schedule
Purpose:
Set the record schedule, and then the camera automatically starts/stops recording according to the configured
schedule.
In this chapter, we take the record schedule procedure as an example, and the same procedure can be applied
to configure schedule for both continuous recording and capture. To schedule the automatic capture, you
need to choose the Capture tab in the Schedule interface.
We use the interface of DS-9000HFI-ST series (unless otherwise stated) as example to describe the following
settings.
Steps:
1. Enter the Record Schedule interface.
Menu > Record > Schedule
Figure 5. 9 Record Schedule
Figure 5. 10 Record Type
The VCA settings and VCA event triggered recording / capture are supported by the analog cameras
01~04 or the smart IP cameras connected to the HDVR only.
To enable Motion, Alarm, M | A (motion or alarm), M & A (motion and alarm) and VCA (Video
Content Analysis) triggered recording and capture, you must configure the motion detection settings,
alarm input settings or VCA settings as well. For detailed information, refer to Chapter 8.1, Chapter
8.2 and Chapter 8.5.
To Next Page
Loading...
