Panic Alarm Master Station • User Manual
25
Display Configuration Page
Enabling HDMI & VGA
Purpose:
The master station can connect to external display of local video via HDMI or VGA interface, external display
needs to be enabled manually.
Enter the display configuration page, slide the slider in the HDMI & VGA line to enable the external display
function. By default, this function is off.
When connected to the external display via the HDMI or VGA interface, the external display displays the
previewing video and receiving alarm video.
Camera Test
The master station supports camera test function.
Enter the display configuration page, click in the Camera Test line, the interface will display the live view
collected by the camera, and you are able to observe the live view for camera test.
Adjusting Screen Brightness
Purpose:
In this section, you can adjust the screen brightness on the display configuration page.
Enter the display configuration page, click “+” or “-” in the Camera Test line to adjust the screen brightness value.
The screen brightness will change in real time with the brightness value. The higher the brightness value, the
brighter the device. The brightness value defaults to 50.
Call Settings
Purpose:
In this section, you are able to configure the call and alarm video for the master station.