10
• Keep in mind that, in some cases, conductors to be measured
may be hot.
• To avoid damaging the power cord, grasp the plug, not the cord,
when unplugging the cord from the power outlet.
• To avoid damaging the voltage cords or clamp sensor cables, do
not bend or pull near their ends.
• Avoid stepping on or pinching the cable, which could damage
the cable insulation.
• Keep the cables well away from heat sources, as bare conduc-
tors could be exposed if the insulation melts.
• When disconnecting the BNC connector, be sure to release the
lock before pulling off the connector. Forcibly pulling the connec-
tor without releasing the lock, or pulling on the cable, can dam-
age the connector.
• Failure to fasten the connectors properly may result is sub-spec-
ification performance or damage to the equipment.
Handling the cords
Maximum input voltage and maximum rated voltage
to earth
• The maximum input voltage of the product is 780 Vrms,
1103 V peak. Do not measure the voltage exceeding that. It
causes the personal injury as well as damages the product.
• The maximum rated voltage to earth of the product is 600
Vrms. Do not measure the voltage to earth exceeding that.
It causes the personal injury as well as damages the prod-
uct.
• The maximum rated voltage to earth of clamp sensor
depends on the type of clamp sensor used.
To avoid electric shock, refer to the instruction manual of a
clamp sensor used.
Input
To Next Page
Loading...
