Hioki 3227 - Page 45

33
────────────────────────────────────────────────────
4.3 Resistance Measurement Mode
────────────────────────────────────────────────────
M
M
300 m
Ω
range 3
Ω
range
M
M
30
Ω
range 300
Ω
range
M
M
k
k
3k
Ω
range 30 k
Ω
range
M
k
300 k
Ω
range
NOTE
The displays change as follows, according to the measuring range (in case of
the resistance value display)
When intend to execute the comparator during using the auto range, the
range becomes the manual range automatically.
During executing the comparator, the auto range is unable to use.
When the sampling rate is FAST, 30k Ω and 300 kΩ range are unable to
select.
During displaying the deviation, the state of the measuring range are not
displayed on the display. To confirm it, turn off the comparator once.
When moving the measuring range under the measurement holding state, the
measuring range is able to change, but the measurement point value is unable
to change.
During temperature conversion display, auto ranging is used. It is not
possible to select the measurement range.