91
────────────────────────────────────────────────────
8.2 Identification of Controls and Indicators
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
①
②
③
NOTE
8.2 Identification of Controls and Indicators
① Interface status display
When using the GP-IB interface
These indicators show the GP-IB control state:
RMT: Remote
PRINT: Talker (printer mode Pr.)
When using the RS-232C interface
These indicators show the RS-232C control state:
RMT: Remote
PRINT: Printer mode Pr.
② DATA OUT/PRINT key
When using GP-IB or RS-232C in talk only mode, measuring value or
setting state can output with this key.
③LOCALkey
・Press this key to release the remote state of the GP-IB or RS-232C interface
and to resume the local state. However, the
LOCAL
key is disabled if the GP-
IB controller has put the unit into the local lock out state.
・Pressing this key in local state resets data of the GP-IB and RS-232C
interfaces.
･ If communication is done by a controller, GP-IB and RS-232C will enter
remote state and will not accept key input. In order to input by key, release
the remote state by pressing the
LOCAL
key.
･ If the remote mode is set in the key lock state, the lock state is released.
To Next Page
Loading...
