Hioki 3332 - Setting the Printer Output; Flowchart; Printer Output Setting Method

49
────────────────────────────────────────────────────
4.8 Setting the Printer Output
────────────────────────────────────────────────────
4.8.1 Flowchart
1. Select the print interval and items
2. Enter the settings.
SHIFT
PRINT
Measurement display
Sets for the printer
PRINT
(or EXIT)
Measurement display
Printer setting display
4.8.2 Printer Output Setting Method
SHIFT
PRINT
Print interval Hours Minutes Seconds (10 second step)
Print item
NOTE
4.8 Setting the Printer Output
When the interface setting is "Pr." mode, it is possible to print data using a
standard printer connected through the GP-IB or RS-232C interface. This
section describes how to set the printing interval and the items to be printed.
(1) Enter the printer setting state.
1. Press the
SHIFT
key and the SHIFT indicator is lit.
2. Press the
PRINT
key.
If there is no flashing indication displayed the settings cannot be changed
(RUN indicator lit).
In this case, return to the measurement state by pressing the
PRINT
key and
press
START/STOP
key to stop integration. Then set again from step 1. (RUN
indicator flashing)