2
────────────────────────────────────────────────────
1.2 Features
────────────────────────────────────────────────────
1.2 Features
(1) Meets the safety requirements of IEC61010-1.
(2) Wide broad band from 1 Hz to 100 kHz.
(3) In reactive power, power factor, and phase indication, it is possible to
recognize the phase is lead or lag.
(4) The current range is wide. (from 1 mA to 50 A)
(5) Analog output for voltage, current, and active power is provided. (3 channels
simultaneously output)
(6) Monitor output (waveform output) for voltage and current is provided. (2
channels simultaneously output)
(7) It is possible to measure the plus, minus, total integrations of power and
current simultaneously.
(8) The terminals for voltage and current measurements are insulated.
(9) All measurement data has synchronism.
(10) By using the GP-IB Interface and the RS-232C Interface, it is possible to
print out this unit's controls and data.
(11) This unit will convert either voltage, current, effective power, apparent
power, reactive power, power factor, phase angle, frequency, integration
value, and current peak value into ±5 V f.s. direct voltage and output from
the D/A output terminal.
(12) With the 50 A range, large currents can be accurately measured.
(13) With the 1 mA range, minute currents can be accurately measured.
(14) The peak value of a current waveform is measured.
(15) With response seting at "SLOW" , stable measurement is possible at 1 Hz
and above.
(16) The delay time from an input to an waveform output is 0.2 to 0.3 seconds.
(with response setting "FAST" )
(17) The comparator comes equipped with two channels that output HI, IN and
LO.
(18) It is possible to save up to 10 settings in memory for the comparator.
(19) When using the comparator, the setting values and instantaneous values
(measurement values) are simultaneously displayed.
To Next Page
Loading...
