Hioki 3332 - Chapter 10 Rack Mounting; Making Rack Mounting Fittings

197
────────────────────────────────────────────────────
10.1 Making Rack Mounting Fittings
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Chapter 10
Rack Mounting
10.1 Making Rack Mounting Fittings
No special metal rack mounting fittings are supplied for the 3332.
If the 3332 is to be rack-mounted, you should make a panel and support
shelf with reference to the figures below.
(1) Fittings for EIA (19-inch) standard rack mounting
The figures show the construction of the panel, if the 3332 is to be fitted to
a EIA standard rack.
Figure 1: Panel for single 3332 unit
Figure 2: Panel for two 3332 units
(2) Fittings for JIS standard rack mounting
The figures show the construction of the panel, if the 3332 is to be fitted to
a JIS standard rack.
Figure 3: Panel for single 3332 unit
Figure 4: Panel for two 3332 units
(3) Fittings for two units coupling rack mounting
The figures show the construction of the panel, if the two units are to be
fitted to a rack.
Two fittings are required for each units.
Figure 5: Panel for two units