42
────────────────────────────────────────────────────
4.5 Setting the Frequency
────────────────────────────────────────────────────
4.5.1 Flowchart
1. Select the frequency source.
2. Select the range.
3. Enter the settings.
SHIFT
AVE･FREQ
Measurement display
Sets the frequency
AVE･FREQ
(or EXIT)
Measurement display
Frequency setting display
4.5.2 Frequency Setting Method
SHIFT
AVE･FREQ
Frequency source
(V or A flashes)
NOTE
4.5 Setting the Frequency
This sets the item to measure the frequency and the frequency range.
Any frequency higher than the set range will be filtered out by an internal
filter, so a stable frequency measurement can be made.
(1) Enter the frequency setting state.
1. Press the
SHIFT
key and the SHIFT indicator is lit.
2. Press the
AVE･FREQ
key. The averaging count is flashing.
3. Press the Setup key, and the frequency source is flashing.
If there is no flashing indication displayed the settings cannot be changed
(during HOLD indicator lit or flashing). In this case, return to the
measurement state by pressing the
AVE･FREQ
key and release the HOLD
state by pressing the
HOLD
key or
SHIFT
→
PEAKHOLD
keys (the HOLD
indicator off). Then set again from step 1.
To Next Page
Loading...
