Hioki 3332 - Displaying Comparator; Flowchart; Comparator Display Setting Method

59
────────────────────────────────────────────────────
4.11 Displaying Comparator
────────────────────────────────────────────────────
4.11.1 Flowchart
1. Press the
TABLE
key and
select the table number.
2. Select the test item to be displayed o
n
display c.
Press the
CH
key to return the
measurement mode.
CH
Measurement display
Sets the comparator
display
Measurement display
Comparator display
CH
4.11.2 Comparator Display Setting Method
CH
Comparator item
Comparator on/off
setting
Limit values
Comparator table
Comparator
channel
Measurement value
NOTE
4.11 Displaying Comparator
It is possible to check instantaneous values of comparator items while
displaying limit values of comparator items. Moreover, instantaneous values
of other measurement items can also be displayed singly.
From the comparator display screen, it is also easy to change the comparator
table number.
Refer to Section 4.10, "Setting the Comparator" for information about the
comparator setting method.
(1) Enter the comparator display.
1. Press the
CH
key.
Limit values are shown in displays a and b; channel number and table
number are shown in display c; and the instantaneous value of the
comparator item is shown in display d.
･ If the
CH
key and the
TABLE
key are pressed when all tables for Comparator
CH1 and CH2 set to OFF, "OFF" is displayed in display "d" for about 1
second, and then the previous display returns.
･ The table number displays the number of the set table.
･ To distinguish the instantaneous value from the limit values in display a and
b, units such as V and A are not lit. Also, the COMP lamp is lit.