Hioki 3332 - Setting the Number of Averaging; Flowchart; Average Setting Method

40
────────────────────────────────────────────────────
4.4 Setting the Number of Averaging
────────────────────────────────────────────────────
4.4.1 Flowchart
1. Set the number of times for averaging.
2. Enter the settings.
SHIFT
AVE･FREQ
Measurement display
Sets the averaging
AVE･FREQ
(or EXIT)
Measurement display
Average setting display
4.4.2 Average Setting Method
SHIFT
AVE･FREQ
Average setting Frequency setting
Flashing
NOTE
4.4 Setting the Number of Averaging
When dealing with input that changes greatly, an average measurement value
is displayed.
This unit does measurement averaging by the number of settings.
(1) Enter the average setting state.
1. Press the
SHIFT
key and the SHIFT indicator is lit.
2. Press the
AVE･FREQ
key.
If there is no flashing indication displayed the settings cannot be changed
(the HOLD indicator lit or flashing). In this case, return to the measurement
state by the
AVE･FREQ
key and release the HOLD state by the
HOLD
key or
SHIFT
→
PEAKHOLD
key (the HOLD indicator off). Then set again from step 1.