Hioki 3332 - Handle and Stand Operations

9
────────────────────────────────────────────────────
1.6 Handle and Stand Operations
────────────────────────────────────────────────────
Handle
Stand
Screws
Screws
Handle
Right side view
NOTE
CAUTION
Be sure not to bear down too hard on the top of the unit when it is
tilted upwards. Doing so may damage the stand.
Stand
NOTE
1.6 Handle and Stand Operations
Removing the handle and stand
If the handle or feet are not required when the
unit is rack-mounted, remove the fixing screws as
shown in the figure on the left.
1. Remove the screws fixing on the handle.
2. Remove the screws on the four feet (two feet
with stands)
Carefully store removed handles, feet, and screws
for use in locations other than the rack.
For the making rack mounting fittings, see
Chapter 10, "Rack Mounting."
Stand operation
The stands move in the direction indicated by the
arrow.
When raising or closing the stands, move them to
where you hear them click into place.
When raising the stands, be sure to raise both the
left and right stand together.