Hioki 3332 - Setting the D;A Output; Flowchart; D;A Output Setting Method

44
────────────────────────────────────────────────────
4.6 Setting the D/A Output
────────────────────────────────────────────────────
CAUTION
To avoid damage to this unit, do not shorten the D/A output terminal
or input voltage.
4.6.1 Flowchart
1. Select the output item.
2. Enter the settings.
SHIFT
D/A
Measurement display
Sets the D/A output
D/A
(or EXIT)
Measurement display
D/A output setting display
4.6.2 D/A Output Setting Method
SHIFT
D/A
Setting item
NOTE
4.6 Setting the D/A Output
Select the D/A output item.
This function will change one of the measurement items (voltage, current
active power, apparent power, reactive power, power factor, phase angle,
current peak, frequency, current integration value or power integration value)
out of the measured value reached by the calculation expression, into analog
waveform.
(1) Enter the D/A output setting state.
1. Press the
SHIFT
key and the SHIFT indicator is lit.
2. Press the
D/A
key.
If there is no flashing indication displayed the settings cannot be changed.
In this case, return to the measurement state by the
D/A
key and release the
HOLD state by the
HOLD
key or
SHIFT
→
PEAKHOLD
keys. Then set again
from step 1.