33
────────────────────────────────────────────────────
4.3 Setting the Integration
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
4.3.1 Flowchart
1. Set the integration time.
2. Enter the settings.
SHIFT
INTEG
Measurement display
Sets the integration
INTEG
(or EXIT)
Measurement display
Integration setting display
4.3.2 Integration Setting Method
SHIFT
INTEG
Hours Minutes Seconds
Integration time
NOTE
4.3 Setting the Integration
This sets integration time. When integrating, some limitations arise for this
unit. In this section, the settings and the integrating method will be
explained.
(1) Enter the integration setting state.
1. Press the
SHIFT
key and the SHIFT indicator is lit.
2. Press the
INTEG
key.
If there is no flashing indication displayed the settings cannot be changed
(during HOLD or RUN indicator lit or flashing). In this case, return to the
measurement state by pressing the
INTEG
or
EXIT
key, and set again after the
integration value is reset or hold state is released.
To reset the integration, use the
START/STOP
key to stop integration (RUN
indicator is flashing) and press
SHIFT
→
RESET
. (Integration value is reset
when the RUN indicator is off).
To release the hold state, press the
HOLD
key when the HOLD indicator is
lit,and press
SHIFT
→
PEAKHOLD
when the HOLD indicator is flashing.
(HOLD state is released when the HOLD indicator is off).
To Next Page
Loading...
