Hioki 3332 - Installation Procedures

200
────────────────────────────────────────────────────
10.2 Installation Procedures
────────────────────────────────────────────────────
WARNING
When installing the unit into the rack, or when installing handle or
stand removed, use the specified screws. Using screws that are
longer than specified will cause internal short circuits, resulting in
destruction of the equipment and a possible electrocution hazard.
①M3×6
(4 locations)
③M4×6
(5 locations)
② M4×12
(2 locations)
①
①
①
①
③
③
③
③
③
②
②
1 unit
2 units
M4×8
(4 locations)
M4×8
(10 locations)
M3×6
(4 locations)
Rack Mounting (EIA)
1 unit
2 units
M4×8
(4 locations)
M4×8
(10 locations)
M3×6
(4 locations)
Rack Mounting (JIS)
10.2 Installation Procedures
1. Referring to the illustration, remove the handle and
screws from the unit.
2. Mount the unit(s) into the rack, using the appropriate
rack mounting fixtures for the type of rack being
used and the number of units being installed using
M4×8mmscrews.
3. When joining two units together, align the joint
fixtures with the sides of the units and fasten them at
the four indicated locations at top and bottom using
M3×6mmscrews.
4. When using rack mounting, reinforce the rack with
commercial available support angles.