85
────────────────────────────────────────────────────
7.5 Making the Connections
────────────────────────────────────────────────────
CAUTION
To avoid damage to this unit, do not shorten the output terminal or
input voltage.
Rear panel
Soldered
Connector cover
Screw
Shielded cable
NOTE
7.5 Making the Connections
When connecting the external control terminal or output terminal, use the
supplied connector (DB-25P-N, DB19678-2 Japan Aviation Electronics
Industry, Limited) or equivalent.
･ Make sure the cord is soldered tightly.
･ To prevent the connector from being detached, be sure to fasten the supplied
screws (M2.6×6) with the connector cover.
･ When plugging and unplugging, always hold the connector cover.
･ Always use shielded cables for output and for external control.
To Next Page
Loading...
