6
────────────────────────────────────────────────────
1.5 Display Reference
────────────────────────────────────────────────────
Indications Meaning
Numbers
Measurement value
m, k, M
Indicates the prefix of unit.
V, A, W, VA, var, PF, ○,
Ip,Hz,Ah,+Wh,-Wh
±Wh, TIME
Indicates the unit and display item.
Voltage, current, active power, apparent power, reactive power, power
factor, phase angle, current peak, frequency, integration current, positive
integration power, negative integration power, total integration power,
integration elapsed time
RMS, MEAN, FILTER
Indicates the rectifier type (RMS: true rms value, MEAN: average
rectifier effectiveness value conversion, MEAN+FILTER: with 500Hz
low-pass filter)
AUTO, 150 to 600
Indicates the voltage range (AUTO: auto-ranging on)
AUTO, 1,2,5,×10,
×100, mA
Indicates the current range (AUTO: auto-ranging on)
SEL
Indicator is lit when the range select function is set.
HI, IN, LO
Indicates the comparator status. Indicator is not lit when the comparator
function is off.
RUN
Indicates integration is in process (when lit), integration is stopped (when
flashing), and integration is in the reset state (when not lit).
SC
Indicator is lit when the PT/CT ratios and SC is other than 1.
AV
Indicator is lit excluding when the number of times of averaging are set
to 1.
HOLD
Indicates hold state (when lit) or peak hold state (when flashing).
KEY LOCK
Indicates key lock status.
SHIFT
Indicates SHIFT status
RMT
The unit is in remote control state.
PRINT
Indicator is lit when the interface is in printer mode, or when GP-IB is
communicating and outputting data.
OVER
Indicates the input's peak value has exceeded the range by 6 times.
o.r
Indicates the value exceeds the display range. (o.r) = out of range
_
, _
(when Hz display)
When displaying Hz, indicates on the left side of display.
"
_
": 100 kHz range, "_": 500 Hz range
----
Indicates the invalid data because of changing frequency.
V, A, W (
flashing)
Indicates that there was the value which is out of range "o.r" during
averaging.
Wh, Ah (
flashing)
Indicates that there was the value which is out of range "o.r" during
integration.
S.Err
Indicates the PT/CT/SC was set so that the scaling result exceeds
99999M at 130% f.s. input. (scaling error)
1.5 Display Reference
To Next Page
Loading...
