62
────────────────────────────────────────────────────
4.12 Selecting Range
────────────────────────────────────────────────────
4.12.1 Flowchart
1. Set the range.
2. Enter the setting.
SHIFT
RANGE SEL
Measurement display
Sets the range.
RANGE SEL
(or EXIT)
Measurement display
Range selecting display
4.12.2 Range Setting Method
SHIFT
RANGE SEL
Current range
On/Off setting
Voltage range
NOTE
4.12 Selecting Range
Ranges are often used in the 3332, so it comes equipped with a function to
designate a required range in order to quickly move to that range; to move to
a range with the
U
,
U
,
I
,
I
keys; and with the auto-ranging function,
to skip unnecessary ranges and quickly move to a required range.
(1) Enter the range setting state.
1. Press the
SHIFT
key and the SHIFT lamp is lit.
2. Press the
RANGE SEL
key.
Display a: Voltage range Display b: Current range
Display c: Setting Display d: Setting
If there is no flashing indication displayed the settings cannot be changed
(during HOLD or RUN lit or flashing). In this case, return to the measurement
state by pressing the
RANGE SEL
key, and set again after the integration
value is reset or hold state is released.
To reset the integration, use the
START/STOP
key to stop integration (RUN
indicator is flashing) and press
SHIFT
→
RESET
. (Integration value is reset
when the RUN indicator is turned off).
To release the hold state, press the
HOLD
key when the HOLD indicator is
lit,and press
SHIFT
→
PEAKHOLD
when the HOLD indicator is flashing.
(HOLD state is released when the HOLD indicator is turned off).
To Next Page
Loading...
