Hioki 3332 - Valid Command According to Condition (Standard Command)

174
────────────────────────────────────────────────────
8.5 Command Summary
────────────────────────────────────────────────────
8.5.3 Valid Command According to Condition
(Standard Command)
Condition
Command
Integration
reset
Key External control
System
error
Integration
RUN
Integration
STOP
Integration
RUN
Integration
STOP
Continue HOLD Continue HOLD Continue HOLD Continue HOLD Continue HOLD
*
CLS
● ● ● ● ● ● ● ● ● ● ●
*
ESE
● ● ● ● ● ● ● ● ● ● －
*
ESE?
● ● ● ● ● ● ● ● ● ● －
*
ESR?
● ● ● ● ● ● ● ● ● ● ●
*
IDN?
● ● ● ● ● ● ● ● ● ● －
*
OPC
● ● ● ● ● ● ● ● ● ● －
*
OPC?
● ● ● ● ● ● ● ● ● ● －
*
RST
● ● ● ● ● ● ● ● ● ● Partly
*
SRE
● ● ● ● ● ● ● ● ● ● －
*
SRE?
● ● ● ● ● ● ● ● ● ● －
*
STB?
● ● ● ● ● ● ● ● ● ● ●
*
TRG
－ ● － ● － ● － ● － ● －
*
TST?
● － － － ● － － － ● － ●
*
WAI
● ● ● ● ● ● ● ● ● ● －
●: can be executed
－: cannot be executed.
Partly : in the event of backup error, the command can be executed. In other errors, a device dependent error is
generated.
Explanations for conditions
Integration reset Integration is stopped and integration time and value
is reset (RUN lamp off)
Integration RUN Integration is in progress (RUN lamp lit)
Integration STOP Integration is stopped (RUN lamp flashing)
Continue Display is being updated at the sampling (continuous
display)
HOLD Display is on hold (HOLD lamp lit or flashing)
System error Err.001 or Err.101 to 105 is displayed
Key Integration started by key operation or interface
command
External control Integration started by external control signal
(START/STOP)