Hioki 3332 - 4.9 Setting the Interface

53
────────────────────────────────────────────────────
4.9 Setting the Interface
────────────────────────────────────────────────────
4.9.1 Flowchart
GP-IB interface:
Set the address.
RS-232C interface:
Select for the baud rate, data length,
parity, stop bit, and communication
mode.
Enter the settings.
SHIFT
INTERFACE
Measurement display
Sets for the interface
INTERFACE
(or EXIT)
Measurement display
Interface display
4.9.2 Interface Setting
SHIFT
INTERFACE
Address
GP-IB interface
RS-232C interface
Baud rate Data length Stop bit
Parity check Communication mode
NOTE
4.9 Setting the Interface
Sets the communication condition for GP-IB interface or RS-232C interface.
(1) Enter the interface setting state.
1. Press the
SHIFT
key and the SHIFT indicator is lit.
2. Press the
INTERFACE
key.
･ GP-IB interface setting
･ RS-232C interface setting
If there is no flashing indication displayed the settings cannot be changed
(RUN indicator lit).
In this case, return to the measurement state by pressing the
INTERFACE
key
and press
START/STOP
key to stop integration. Then set again from step 1.
(RUN indicator flashing)