Hioki 3332 - Connecting to the Printer

52
────────────────────────────────────────────────────
4.8 Setting the Printer Output
────────────────────────────────────────────────────
4.8.3 Connecting to the Printer
NOTE
NOTE
(1) Printer for the GP-IB
1. Set the printer to listen only.
2. Connect the 3332 to the printer by using the GP-IB cable.
(2) Printer for the RS-232C
1. Match the settings of the printer and the 3332. (Baud rate, data length,
stopbit, and parity)
2. For details on the setting method of the 3332, refer to Section 4.9, "Setting
the Interface."
3. Connect the 3332 to the printer by using the RS-232C cable.
･ Depending on the printer, either the pin 2 or the pin 3 is the receiver pin.
If the pin 2 is the receiver pin, use a straight cable.
If the pin 3 is the receiver pin, use a cross cable.
For the cross cable, use the type indicated in Section 8.1.2, "RS-232C
Interface", example for RS-232C cable connections.
･ For interface cables, use screws to secure the cable. Also, always use
shielded cables for the cable to be used.
(3) Setting the 3332
Set to Pr. mode on the 3332. (Refer to Section 4.9, "Setting the Interface".)
(4) Printing sample
Refer to Section 8.7, "Printer Output Function."
The printer must print either 40 characters per line, or 80 or more characters
per line.