74
────────────────────────────────────────────────────
6.2 System Resetting
────────────────────────────────────────────────────
Items Settings
Display a Voltage
Display b Current
Display c Active power
Display d Power factor
Response Auto
Voltage range/ Current range Auto-range
Rectifier type RMS
Frequency range Auto-range
Frequency measurement source Voltage
Integrate time 10000:00 (10,000 hours)
PT/ CT/ SC 1.000
D/A output items Apparent power
The number of averaging 001 (No averaging)
Comparator OFFbothchannels1and2
Comparator upper limit 0.0000k (all tables)
Comparator lower limit 0.0000k (all tables)
Comparator item (CH1) Active power (P)
Comparator item (CH2) Current (I)
Communication interface GP-IB
Range setting All ON
GP-IB address 1
RS-232C
Baud rate 9600 bps
Data length
8bits
Parity bits
none
Stop bits
1bit
Communication
mode
Co.
Hold OFF (continuous display)
Printing items V, A, W, +Wh, TIME
Print interval time 00:00:00 (interval printing: OFF)
6.2 System Resetting
To carry out a system reset, power on the unit, and hold down the
SHIFT →
RESET
keys during the self test.
This returns all of the settings to their initial values. (These are the same as
the settings when the unit is initially shipped from the factory.)
The integration elapsed time and integration value are also reset.
To Next Page
Loading...
