Hioki 3332 - Page 64

50
────────────────────────────────────────────────────
4.8 Setting the Printer Output
────────────────────────────────────────────────────
▼
▲
Setting the value
Moving digit
NOTE
Flashing
000.00.0 → Time
V → Voltage
A → Current
W → Active power
VA → Apparent power
var → Reactive power
PF → Power factor
○ → Phase angle
lp → Current peak
Hz → Frequency
Ah → Current integration
+Wh → Positive power integration
-Wh → Negative power integration
±Wh → Total power integration
TIME → Integration time
(2) Set the print interval and print item.
1. To move the flashing point, press the or Setup key.
2. To set the value on the flashing digit, press the ▲ or ▼ Setup key.
･ The smallest unit of setting limit is 10 seconds and biggest is 100 hours. If
the setting exceeds this limit, it is forcibly set to 100 by pressing the
ENTER
key.
･ When this setting is used, data is printed by the printer at the same time as
the start of integration.
･ When it is 000.00.0, the unit will not print at the same time as integration.
･ If the number of printed items is large, printing may not be possible within
the specified printing interval. In this case, make the printing interval longer,
or reduce the number of items.
3. If in the seconds column and the key is pressed, or in the left hand
column of the hour columns and key is pressed, the display will change to
the setting of the print item.
Pressing the key moves flashing point according to the following cycle.
Pressing the key moves reversely.