Hioki 3332 - Page 162

148
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
■ Set the integration condition.
Syntax
INTEGrate:STATe_<START/ STOP/ RESET>
Function
Sets the condition of the integrate operation (start, stop or reset).
Errors
･ Device dependent error/ according to the "RUN" indicator.
Data portion Off
Key input (command) External control
Lit Flashing Lit Flashing
START
● － ● － －
STOP
－ ● － － －
RESET
● － ● － ●
●: The command is executed. / －: A device dependent error is generated.
･ System error/ This query is not executed. A device dependent error occurs.
･ Depending on the external control, an error may occur during integration
operation. (See Section, 8.5.4.)
･ Device dependent error/
① When the integration time reached 10000 hours
② When the START command is executed with the integration value is
999999M
Example
Transmission
":INTEG:STAT START"
Starts integrating.
■ Queries the integration condition.
Syntax
INTEGrate:STATe?
Function
Returns the condition of integrate operation (START/STOP/RESET) as a
character data.
Note
With this query, if any error occurs, no response message is produced.
Response
syntax
Headers: ON
Headers: OFF
":INTEGRATE:STATE_<START/STOP/RESET>"
"<START/STOP/RESET>"
Errors
･ Query error/ If the response message is longer than 1000 bytes.
･ System error/ This query is not executed. A device dependent error occurs.
Example
Transmission
Response
Headers: ON
Headers: OFF
":INTEG:STAT?"
":INTEGRATE:STATE START"
"START"
INTEGrate:STATe
INTEGrate:STATe?