Hioki 3332 - Page 174

160
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
■ Queries the PT ratio.
Syntax
SCALe:PT?
Function
The current value of PT ratio is returned as a numerical value in NR2
numerical format.
Note
With this query, if any error occurs, no response message is produced.
Response
syntax
Headers: ON
Headers: OFF
":SCALE:PT_<NR2>"
"<NR2>"
Errors
･ Query error/ If the response message is longer than 1000 bytes.
･ System error/ This query is not executed. A device dependent error occurs.
Example
Transmission
Response
Headers: ON
Headers: OFF
":SCAL:PT?"
":SCALE:PT 5.000"
"5.000"
■ Sets the SC.
Syntax
SCALe:SC_<NR2>
<NR2>
0.001 to 9999.0
Function
･ The current value of SC is set.
･ <NR2> can be accepted in NRf format, but its effective value will be obtained
by rounding off the fifth digit on the basis of 5 and above being rounded up
and 4 and below being rounded down.
Errors
･
Execution error/ If the setting data is other than listed above.
･
Command error/ If the setting data is not in NRf format.
･ Device dependent error/
① In the event of a system error
② If this command is executed in the hold state
(HOLD indicator lit or flashing)
③ During integrating (RUN indicator lit)
Example
Transmission
":SCAL:SC 10.00"
The SC is set to 10.00.
SCALe:PT?
SCALe:SC