133
Command Reference
:MEASure:CLEar
Clears measured value and judgment result.
The status is changed so that no judgment has been made.
Syntax
:MEASure:CLEar
Example To clear the measured value and judgment result
PC>
:MEASure:CLEar
:MEASure:MONItor?
Queries the voltage monitor value. The rvoltage monitor value is returned in NR1 numerical data
(<data>)
No command header is included in response.
Syntax
:MEASure:MONItor?
Response
:<data>
<data> Voltage monitor value (unit: V) 0 to 1000 (resolution 1V) (NR1)
Example To query the voltage monitor value (when the voltage monitor value is 25 V)
PC>
:MEASure:MONItor?
ST5520>
25
:VOLTage
Sets the test voltage.
When the testing start command,
:STARt
is sent sequentially after the test voltage is changed,
a time of up to 500 ms is added until the test starts.
Syntax
:VOLTage <data>
<data> Test voltage 25 to 1000 (NR1 numerical data)
Example To set the test voltage to 100 V
PC>
:VOLTage 100
:VOLTage?
Queries the test voltage. The test voltage is returned in NR1 numerical data (<data>).
Syntax
:VOLTage?
Response
:VOLTAGE <data>
or simply
<data>
<data> Test voltage 25 to 1000 (NR1 numerical data)
Example To query the test voltage (when the test voltage is 100 V)
PC>
:VOLTage?
ST5520>
:VOLTAGE 100
(when the
:HEADer
command is ON)
ST5520>
100
(when the
:HEADer
command is OFF)
10
9
8
7
6
5
4
3
2
1
Appx. Ind.
To Next Page
Loading...
