Hioki ST5520-01 - Power and Measurement Lead Connections

10
Usage Notes
IMPORTANT
When using the instrument, be sure to use the connecting lead wires, etc.
specied by our company. When other cords and lead wires are used, accurate
measurement may not be possible because the connection becomes poor, etc.
Before connecting the power cord
WARNING
• To avoid electric shock and to maintain the safety specications
of this instrument, connect the power cord provided only to a
3-contact (two-conductor + ground) outlet.
• Use only the designated power cord with this instrument. Use of
other power cords may cause re.
CAUTION
To avoid damaging the power cord, grasp the plug, not the cord, when
unplugging it from the power outlet.
IMPORTANT
Turn off the power before disconnecting the power cord.
Before connecting measurement leads
DANGER
To avoid electric shock and short circuit accidents, turn off all power
of the measurement target before connecting measurement leads.
WARNING
To avoid electrical accidents, use the designated wires or ones with more
than enough dielectric strength and current capacity.
UL1032 AWG18
Twisted wires 75 wires ×
φ
0.12 mm