Hioki ST5520-01 - Probe and Residual Risk Precautions

11
Usage Notes
Before connecting switched probes
CAUTION
To avoid damage to the probes, do not bend or pull the probe base.
To ensure safe operation, use only the probes specied by our company.
Residual risk
WARNING
The test leads generate high voltage. To avoid electric shock, do not
touch the metal ends of the test leads.
CAUTION
The ends of the probes are sharp. Be careful to avoid injury.
Before connecting data cables
WARNING
• Failure to fasten the connectors properly may result in sub-
specication performance or damage to the equipment.
• Always turn off both devices when connecting and disconnecting
an interface connector. Otherwise, an electric shock accident may
occur.
Before switching between current sink (NPN) and current source (PNP)
CAUTION
Do not operate the EXT.I/O mode switch (NPN/PNP) while the instrument is
on.
Congure the NPN/PNP setting to accommodate externally connected
equipment.
10
9
8
7
6
5
4
3
2
1
Appx. Ind.