Hitachi 65 - Attaching and Removing Rack-Mounting Metal Fittings (Option)

6. CHECKUP AND MAINTENANCE
6-20
6.3.8 Attaching and removing rack-mounting metal fittings (option)
CAUTION
⚫ Rack-mounting metal fittings are designed to be used for pulling out the
equipment toward the front by hooking your fingers on the handles.
Do not grip the handles to lift up or carry the equipment.
If you do, the equipment may fall and personal injury may result.
⚫ Thoroughly check if the rack-mounting metal fittings are attached properly.
If they are not attached properly or the screws are loose, the equipment may
fall and personal injury may result.
NOTICE
The orientation of a rack-mounting metal fitting is fixed if it is to be attached to
the equipment. Make sure the orientation is correct.
(1) Before attaching or removing rack-mounting metal fittings
・Before starting to work, see “6.3.2 Before installing or removing components”.
< NOTE >
・ For information about the precautions for rack-mounting metal fittings, see
“PRECAUTIONS 8. RACK-MOUNTING METAL FITTINGS”.