Hitachi 65 - Maintenance Operation Commands; Table 8-3 Maintenance Operation Commands

8. MAINTENANCE OPERATIONS
8-12
8.4 Maintenance Operation Commands
This section explains how to use maintenance operation commands. These commands are
used when problems occur in the equipment and during preventive maintenance. All these
commands are started at the command prompt when they are used.
Table 8-3 shows a list of maintenance operation commands.
Table 8-3 Maintenance Operation Commands
Command name
Feature
logsave
Used for collecting data for preventive maintenance or data for post-
failure analysis during preventive maintenance or when problems
occur.
mdump
Used for copying a memory dump file to a portable medium when a
memory dump is collected due to a STOP error.
createdmp
Used for reserving a disc area for a memory dump file when a message
is displayed indicating the capacity of the memory dump file is
insufficient.
getrasinfo
Used for checking the status of the equipment such as the status of the
fan and the temperature inside the chassis.
The Manufacturer provides charged services to analyze the data collected by these
maintenance operation commands, such as memory dump files and data for failure analysis.